Stuska Engine Dyno Dynamometer - 1200 HP Dual Absorber

Description

Up for sale is a Stuska 1200 HP dual absorber water brake dyno.
This dyno is used and appears to have been setup for stock car or dirt car racing.
The frame you see pictured includes the pillow block bearings, load cell for measuring torque, a shaft with flywheel/ring gear and a starter.
Splined shaft appears to fit standard Chevy clutch spline. This dyno stand would require a standard transmission bell housing adapter for the engine you want to run.
Dyno absorber can be repurposed with your own custom stand.
Also included are (2) Paco 10 HP pumps and two giant mufflers.
The Paco pumps are rated for 150 gallons/minute (but can go to 180 gallons/minute) and are cable of providing sustained water flow to the dynos at 1200 HP. Stuska recommends 1 gallon/minute per 10 hp absorbed by the dyno. At 150 gallon/minute that would allow this unit to absorb 1600 HP with only modifications to the water inlets.
It comes with stand to mount the dyno, frame to allow the dyno to bolt to a transmission bell housing of your choice.
In order to run this dyno you will need a water tank or city water supply capable of meeting your hp requirements of 1 gallon/minute per 10 HP. If you use the pumps you will need a method of flow control and load control.
Lifting bar shown in pictures is not part of the sale.